Technical specifications for IC660BBD023
Brand GE Fanuc
Series Genius I-O
Part number IC660BBD023
Describes the Sink I/O block
The voltage is 24 volts DC
Circuit 16
Rated load current 2 amps
Optional filter time 10-100 ms
Heat dissipation of 68.8 watts, 2 amps
Steady state output current 2 amps
Output OFF leakage current 1.9 MA
Temperature 0-60 degrees Celsius

The IC660BBD023 I/O block is the 24 volt DC rated I/O block of GE Fanuc. It is UL compliant and complies with different industry standards. It is compatible with 2-wire and 3-wire sensors and is part of the GE Genius I-O PLC system. It is equipped with 16 individual circuits that can be used as input, output or three-state input. The rated load current of the I/O block is 2 amps. This smart I/O device is used to connect various input and output devices. It is also compatible with DC sensor and actuator devices. The Genius I/O device has an open architecture that should protect against water splashes, dust and air pollutants. It can only be used in indoor locations. The front of the block has LED indicators to monitor the status of the device and I/O.

For internal communication, the IC660BBD023 I/O block has 2 serial ports, called serial port 1 and Serial port 2. It also comes with a Shield In port and a Shield Out port. I/O blocks can be configured or monitored using a programmable controller connected to a monitoring port. The IC660BBD023 I/O module provides short circuit protection, overheat protection, fault switch detection, overload detection, and open circuit detection. The module provides optional input filter times between 10 ms and 100 ms. During normal operation, when using 16 2 amp outputs, the IC660BBD023 I/O module dissipates 68.8 watts of heat. The steady state output current is 2 amps per circuit, and the output off state leakage current is 1.9 mA. The temperature of the operating environment should be set between 0 and 60 degrees Celsius.